Zanussi ZDT12011FA User Manual download pdf (Page 8)

German degrees

(°dH)

French degrees

(°fH)

mmol/l Clarke degrees

Water softener

level

11 - 14 19 - 25 1.9 - 2.5 13 - 17 3

4 - 10 7 - 18 0.7 - 1.8 5 - 12 2

<4 <7 <0.7 < 5

1) Factory setting

2) Do not use salt at this level.

ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME

By default this acoustic signal is deactivated but it is possible to activate it.

1. While the appliance is in user mode, within about 5 seconds press programme button: the indicator

is on and the indicator starts to flash.

2. Wait until the indicator goes off. The indicator is off. The acoustic signal is off.

3. Press programme button to change the setting. The indicator is on. The acoustic signal is on.

4. Press on/off button to confirm the setting.

BEFORE FIRST USE

1. Make sure that the current level of the

water softener agrees with the hardness

of the water supply. If not, adjust the level

of the water softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any processing

residuals that can still be inside the appliance.

Do not use detergent and do not load the

baskets.

When you start a programme, the appliance can

take up to 5 minutes to recharge the resin in the

water softener. It seems that the appliance is not

working. The washing phase starts only after this

procedure is completed. The procedure will be

repeated periodically.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Zanussi ZDT12011FA User Manual Page 8