Zanussi ZDT201 User Manual

GBUser manual 2DishwasherZDT201

123Fill the detergent dispens-er (A) with detergent.4If you use a washing pro-gramme with prewashphase, put more detergentin the prewash detergentcomp

Cancelling a washing programme1. Press and hold the programme selection/cancel but-ton for approximately 3 seconds.– The programme indicator light goe

12Fully clean the filters A, Band C below running wa-ter.3To remove filters B and C,turn the handle approxi-mately 1/4 anticlockwise.4Remove the flat

Fault code and malfunction Possible cause and solution• continuous flash of the light of the run-ning programme• intermittent audible signal• 1 flash

The cleaning results are not satisfactoryThe dishes are not clean • The selected washing programme is not applicable for the type of load andsoil.• Th

Warning! To discard the appliance, follow theprocedure:• Pull the mains plug out of the socket.• Cut off the mains cable and mains plug and discardth

34The internal diameter must not be smaller than the diam-eter of the hose.If you connect the water drain hose to a trap spigot underthe sink, remove

17

18

19

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Washing programmes _ _ _ _ _ _ _ _

To buy accessories, consumables and spare parts at our online shop please visit:www.zanussi.co.ukwww.zanussi.com156951350-00-042009

• Do not change the specifications or modify this prod-uct. Risk of injury and damage to the appliance.• Do not use the appliance:– if the mains cable

Indicator lights1)The indicator light comes on when it is necessary to fillthe salt container. Refer to the chapter 'Use of dishwashersalt'.

Washing programmesWashing programmesProgramme Degree of soil Type of load Programme descriptionHeavy soilCrockery, cutlery,pots and pansPrewashMain wa

Use of the applianceRefer to the following instructions for each step of pro-cedure:1. Make a check if the water softener level is correct forthe wate

12Set switch to position 1 or2.Electronic adjustmentThe water softener is set at the factory at level 5.1. Switch on the appliance.2. Make sure that t

Use of rinse aidCaution! Only use branded rinse aid fordishwashers.Do these steps to fill the rinse aid dispenser:1 2M A X1 2 3 4 +34Caution!

1Arrange service dishesand large lids around theedge of the lower basket.212Use the cutlery grid. If the dimensions of the cutleryprevent use of the c