Zanussi ZRB23200WA User Manual download pdf (Page 23)

23

www.zanussi.com

Installation

Read the Safety information carefully for

your safety and correct operation of the

appliance before installing the appliance.

Positioning

Install this appliance at a location where the

ambient temperature corresponds to the

climate class indicated on the rating plate of

the appliance:

Climate class Ambient temperature

SN +10ºC to +32ºC

N +16ºC to +32ºC

ST +16ºC to +38ºC

T +16ºC to +43ºC

Location

The appliance should be installed well away

from sources of heat such as radiators,

boilers, direct sunlight etc. Ensure that air

can circulate freely around the back of the

cabinet. To ensure best performance, if the

appliance is positioned below an overhanging

wall unit, the minimum distance between the

top of the cabinet and the wall unit must be at

least 100mm. ldeally, however, the appliance

should not be positioned below overhanging

wall units. Accurate leveling is ensured by

one or more adjustable feet at the base of the

cabinet.

Warning! It must be possible to

disconnect the appliance from the

mains power supply; the plug must

therefore be easily accessible after

installation.

Electrical connection

Caution! Any electrical work required

to install this appliance should be

carried out by a qualiﬁed electrician or

competent person.

Warning! This appliance must be

earthed. The manufacture declines any

liability should these safety measures

not be obse

Important!

The wires in the mains lead are colored in

accordance with the following code:

1

Green and Yellow: Earth

2

Brown: Live

3

Blue: Neutral

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings indentifying the terminals

in your plug, proceed as follows:

1. Connect the wire coloured green and

yellow to the terminal marked either with

the letter “E” or by the earth symbol or

coloured green and yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter

“N” or coloured black.

3. Connect the wire coloured brown to the

terminal either marked with the “L” or

coloured red.

4. Check that no cut, or stray strands of

wire is present and the cord clamp

4

is

secure over the outer sheath.

5. Make sure the electricity supply voltage

is the same as that indicated on the

appliance rating plate.

6. Switch on the appliance. The appliance

is supplied with a 13 amp plug ﬁtted

2

. In the event of having to change

the fuse in the plug supplied, a 13 amp

ASTA approved (BS 1362) fuse must

be used.

Warning! A cut off plug inserted into a

13 amp socket is a serious safety

(shock) hazard. Ensure that it is

disposed of safety.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Comments to this Manuals

No comments