Zanussi ZI7280D User Manual download pdf (Page 6)

TECHNICAL SPECIFICATIONS

Open both the appliance door and that of the

kitchen unit to approx. 90°. Place the little plates

over the runners. Hold the doors of the appliance

and the unit together and mark the holes.

Remove the little plates and make the holes with

a diam. of 2 mm. Replace the little platee over

the runners and screw in the screws provided

(3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that

the doors of the appliance and the kitchen unit

open properly.

If the appliance is to be fitted laterally to the

kitchen unit, it will be sufficient to loosen the

screws of the little plates (G), move them as

shown in Fig. 11 and then fasten them up again.

Fit the cover (H).

8mm

PR34

PR35

D729

Fig. 8

Fig. 9

Fig. 10

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

1 2 3 4 5 6 7 8 9 10

No comments

Zanussi ZI7280D User Manual Page 6