Zanussi PX64 User Manual

GAS HOBMODELSPN 64PS 64PW 64PX 64PTDF 64INSTRUCTION BOOKLETIL35673-2502

10Electrical connectionsAny electrical work required to install this applianceshould be carried out by a qualified electrician orcompetent person, in

11CommissioningWhen the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below.- T

2

3For the UserContentsGuide to Use the instructionsThe following symbols will be found in the text to guideyou throughout the Instructions:Safety Instr

41. Hob Top2. Auxiliary Burner3. Semi-rapid Burners4. Powered Rapid Burner5. Control knob for front left burner (auxiliary)6. Control knob for back le

5OperationThis hob is provided with a safety device, whichwill stop the gas flow if the flame accidentally goesoff during cooking.To light a burner:-

6Before any maintenance or cleaning can becarried out, you must DISCONNECT the hobfrom the electricity supply.The hob is best cleaned whilst it is sti

7 SOLUTION Check that the unit is plugged in and the electricalsupply is switched on. Check the mains fuse has not blown. Check the burner cap an

8Building InBuilding over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawer itwill be necessary to fit a heat resistant boar

9FO 0198Building over a kitchenunit with ovenIf the hob is built into a kitchen unit with anoven underneath, the recess must have thedimensions shown