Zanussi ZCK95206WA User Manual download pdf (Page 8)

Initial Cleaning

Remove all accessories from the appliance.

Refer to "Care and cleaning"

chapter.

Clean the appliance before first use.

Put the accessories back to their initial position.

Preheating

Preheat the empty appliance to burn off the

remaining grease.

1. Set the function and the maximum

temperature.

2. Let the appliance operate for 1 hour.

3. Set the function and the maximum

temperature.

4. Let the appliance operate for 15 minutes.

Accessories can become hotter than usual. The

appliance can emit an odour and smoke. This is

normal. Make sure that the airflow in the room is

sufficient.

Hob - Daily use

WARNING!

Refer to Safety chapters.

Ignition of the hob burner

Always light the burner before you

put on the cookware.

WARNING!

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

In the absence of electricity you can

ignite the burner manually.

Ignition of a hob burner with the

thermocouple

• For manual ignition put the flame near the

burner. Push the knob for the hob down and

turn it counterclockwise to the maximum gas

flow position .

• For integrated ignition on knob push the

knob for the hob down and turn it

counterclockwise to the maximum gas flow

position .

Keep the knob for the hob pushed for equal or

less than 10 seconds to let the thermocouple

warm up. If not, the gas supply is interrupted.

Adjust the flame after it is regular.

WARNING!

Do not keep the knob pushed for

more than 15 seconds. If the burner

does not light after 15 seconds,

release the knob, turn it into the off

position and try to light the burner

again after minimum 1 minute.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

If the burner accidentally goes out,

turn the knob to the off position and

try to light the burner again after

minimum 1 minute.

Burner overview

A

B

D

C

8 www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments