Zanussi ZEI6840FBV User Manual download pdf (Page 12)

Problem Possible cause Remedy

and a number come on.

There is an error in the hob. Disconnect the hob from the

electrical supply for some time.

Disconnect the fuse from the

electrical system of the house.

Connect it again. If comes on

again, speak to an Authorised

Service Centre.

comes on.

There is an error in the hob be-

cause a cookware boiled dry. Au-

tomatic Switch Off and the over-

heating protection for the zones

operate.

Deactivate the hob. Remove the

hot cookware. After approximate-

ly 30 seconds, activate the zone

again. If the cookware was the

problem, the error message goes

out. Residual heat indicator can

stay on. Let the cookware be-

come sufficiently cool. Check if

your cookware is compatible with

the hob.

Refer to “Hints and tips” chapter.

If you cannot find a solution...

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating

plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass

surface) and an error message that comes on.

Make sure, you operated the hob correctly. If

not the servicing by a service technician or

dealer will not be free of charge, also during the

warranty period. The instructions about the

Service Centre and conditions of guarantee are

in the guarantee booklet.

Installation

WARNING!

Refer to Safety chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

Connection cable

• For a single phase or two phase connection

use the following (or higher) mains cable

type: H05V2V2-F T min 90°C.

12 www.zanussi.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments