Zanussi ZEV6240FBA User Manual download pdf (Page 10)

CLEANING THE HOB

• Remove immediately: melted plastic, plastic

foil, sugar and food with sugar, otherwise, the

dirt can cause damage to the hob. Take care to

avoid burns. Use a special hob scraper on the

glass surface at an acute angle and move the

blade on the surface.

• Remove when the hob is sufficiently cool:

limescale rings, water rings, fat stains, shiny

metallic discoloration. Clean the hob with a

moist cloth and a non-abrasive detergent. After

cleaning, wipe the hob dry with a soft cloth.

• Remove shiny metallic discoloration: use a

solution of water with vinegar and clean the

glass surface with a cloth.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

WHAT TO DO IF...

Problem Possible cause Remedy

You cannot activate or operate

the hob.

The hob is not connected to an

electrical supply or it is con-

nected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connection

diagram.

The fuse is blown. Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

You do not set the heat setting

for 10 seconds.

Activate the hob again and set

the heat setting in less than 10

seconds.

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

There is water or fat stains on

the control panel.

Clean the control panel.

An acoustic signal sounds and

the hob deactivates.

An acoustic signal sounds

when the hob is deactivated.

You put something on one or

more sensor fields.

Remove the object from the

sensor fields.

The hob deactivates. You put something on the sen-

sor field .

Remove the object from the

sensor field.

Residual heat indicator does

not come on.

The zone is not hot because it

operated only for a short time

or the sensor is damaged.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.

The sensor fields become hot. The cookware is too large or

you put it too near to the con-

trols.

Put large cookware on the rear

zones if possible.

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments