2GAS HOBMODEL ZGF 759INSTRUCTION BOOKLET
11Building InBuilding over a cupboard or drawerIf the hob is to be installed above a cupboard ordrawer it will be necessary to fit a heat resistant bo
125050FO 2039FO 0199aCarry out the building in of the hob as follows:• put the seals supplied with the hob, on theedges of the cut out: place them exa
13Electrical connectionsAny electrical work required to install thisappliance should be carried out by aqualified electrician or competent person,in a
14CommissioningWhen the hob has been fully installed it will benecessary to check the minimum flame setting. To dothis, follow the procedure below.- T
15A: Removal Of Hob Top1. Remove all control knobs, pan supports, burner capsand burner crowns.2. Remove 2 screws for each burner.3. Remove 6 fixing s
3Important Safety InformationYou MUST read these warnings carefully before installing or using theappliance.Installation● This appliance must be insta
4For the UserDescriptionof the Hob Page 5Operation Page 6Maintenanceand Cleaning Page 7SomethingNot Working Page 8ContentsFor the InstallerTechnical D
51. Hob Top2. Auxiliary Burner3. Semi-rapid Burners4. Rapid Burner5. Ignition pushbutton6. Control knob for front left burner (auxiliary)7. Control kn
6OperationTo light a burner, turn the relevant control knobanticlockwise to maximum position and push it downto ignite. Keep the control knob pressed
7Before any maintenance or cleaning can becarried out, you must DISCONNECT thehob from the electricity supply.The hob is best cleaned whilst it is sti
8Something Not Working?If the appliance is not working correctly, please carry out the following checks before contacting your localService Centre.
9OVERALL DIMENSIONSWidth: 680 mm.Depth: 510 mm.Height: 72 mm.Weight: 12 Kg.CUT OUT DIMENSIONSWidth: 560 mm.Depth: 480 mm.Thickness: 30 mm.Instructions
10Rectangular cut-out size for hob560150 min48055 min.FO 2038Dimensions are given in mm.InstallationCut Out SizeThe dimensions of the cut-out are give
Comments to this Manuals