Zanussi ZGG642CN User Manual download pdf (Page 10)

Building In

Dimensions are given in mm.

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer

it will be necessary to fit a heat resistant board below

the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

FO 2320

Building over a kitchen unit with

door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the

bottom of the hob which can be heated when it is

operated. The recommended solution is shown in

diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

FO 1013

ON/OFF SWITCH

FLEX

OUTLET

FO 0764

sealing

gasket

FO 2321

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive seal

must be fitted to the underside outside edge (Fig. 11) of

the hob. It is essential that no gaps are left in this seal in

order to prevent spillage near the hob seeping into the

cabinet below.

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down, taking care

the ignition candles are not damaged in this operation.

2) Place the sealing gasket all around the glass top edge

as shown in diagram 4.

3) Place the hob in the cut out, taking care that it is

centred. Fix the hob with the relevant fixing clamps,

supplied with the injectors kit (diagram 5).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Zanussi ZGG642CN User Manual Page 10

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZGG642CN