Zanussi ZVT64X User Manual download pdf (Page 19)

face at an acute angle and move the

blade on the surface .

– Remove after the appliance is suffi-

ciently cool: limescale rings , water

rings, fat stains, shiny metallic discolora-

tions. Use a special cleaning agent for

glass ceramic or stainless steel.

2. Clean the appliance with a moist cloth and

some detergent.

3. At the end rub the appliance dry with a

clean cloth.

Troubleshooting

Problem Possible cause Remedy

You cannot activate the appliance

or operate it.

The appliance is not connected to

an electrical supply or it is connec-

ted incorrectly.

Check if the appliance is correctly

connected to the electrical supply

(refer to connection diagram).

Activate the appliance again and

set the heat setting in less than 10

seconds.

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

There is water or fat stains on the

control panel.

Clean the control panel.

An acoustic signal sounds and the

appliance deactivates.

An acoustic signal sounds when

the appliance is deactivated.

You put something on one or more

sensor fields.

Remove the object from the sen-

sor fields.

The appliance deactivates. You put something on the sensor

field

Remove the object from the sen-

sor field.

The residual heat indicator does

not come on.

The cooking zone is not hot be-

cause it operated only for a short

time.

If the cooking zone operated suffi-

ciently long to be hot, speak to the

service centre.

The sensor fields become hot. The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

cooking zones if necessary.

comes on.

The Automatic Switch Off oper-

ates.

Deactivate the appliance and acti-

vate it again.

comes on.

The Child Safety Device function

operates.

Refer to the chapter “Daily Use”.

and a number come on.

There is an error in the appliance. Disconnect the appliance from the

electrical supply for some time.

Disconnect the fuse from the elec-

trical system of the house. Con-

nect it again. If

comes on

again, speak to the service centre.

If you tried the above solutions and cannot re-

pair the problem, speak to your dealer or the

customer service. Give the data from the rating

plate, three digit letter code for the glass ceram-

ic (it is in the corner of the glass surface) and an

error message that comes on.

Make sure, you operated the appliance correct-

ly. If not the servicing by a customer service

technician or dealer will not be free of charge,

www.zanussi.com

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Comments to this Manuals

No comments

Zanussi ZVT64X User Manual Page 19

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZVT64X