Check whether or not there are active carbon filters inside the body of the hood; in the remote blower
version they should not be fitted (see paragraph 3.3 part 2)
2 - Connecting up filter system
The hood must be connected to the top portion of the overhead unit using a 0 120 mm rigid or
flexible pipe.
Check that the active carbon filters are fitted inside the body of the hood (see paragraph 3.3. part 2).
The filtered air is returned to the environment through the opening at the top of the overhead unit.
If provided, a 0 120 mm directional vent can be installed on top of the overhead unit, making sure
that the air flow is not directed against the wall.
3,4 - Connecting to the power supply and testing
Connection to the power supply is as follows;
1 - If the hood is equipped with a plug, this can be connected directly to a near-by power socket, provided
the latter is adequately earthed.
2 - If the hood does not have a plug, it must be connected by means of a special power line, which must
be suitably earthed.
The warnings given in points 2,3, 2.4 and 2.5 of the safety precautions must always be observed.
3 - After connecting to the mains power supply, check that the lighting, motor starl-up and speed change
all operate correctly.
After installing the huod, the pull-out undercarriage must be opened with a certain force, until
a click is heard indicating that it has reached its full extension.
Part 2 - OPERATION AND MAINTENANCE INSTRUCTIONS
1 - SAFETY WARNINGS
It is most important that all the warnings shown in paragraph 3 of part 1 are strictly observed.
Moreover, special attention must be paid to the following warnings during the use and maintenance
of the cooker hood:
1.1 - The grease filters and the charcoal filters should be cleaned or replaced as recommended by the
manufacturer or more frequently if the hood is used consistently (more than 4 hours per day).
1.2 • When using a gas hob in connection with the cooker hood never leave the burners of the hob
uncovered while the hood is in use or when the pans have been removed. Switch off the gas
before removing the pan or for just short periods and never leave the hob unattended.
13 - Always ensure that the appliance is kept at the correct intensity to prevent the flame from
licking round from the bottom of the pan; this will save energy and will avoid a dangerous
concentration of heat.
1.4 - Always ensure that the appliance is used in accordance with the manufacturer’s instructions for
the removal of contaminated odours during cooking.
USE
Control panel
The cooker hood can be operated as follows:
LIGHT SWITCH - controls the worktop illumination;
MOTOR SWITCH - controls the power to the motor and the fan speed:
Position 1 = low speed, should be selected when simmering or using only one pan: the noise level
is kept to the minimum.
Position 2 = medium speed, should be selected for normal cooking. This .speed offers the best ratio
between air capacity and noise level.
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals