Zanussi ZBA22420SA User Manual download pdf (Page 19)

Problem Possible cause Solution

Water flows on the ground. The melting water outlet does not flow

in the evaporative tray above the com-

pressor.

Attach the melting water outlet to the

evaporative tray.

The temperature in the appliance

is too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The temperature in the appliance

is too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

Many products are stored at the same

time.

Store less products at the same time.

There is no cold air circulation in the

appliance.

Make sure that there is cold air circula-

tion in the appliance.

Replacing the lamp

Caution! Disconnect the plug from the mains

socket.

Remove the screw from

the lamp cover.

Remove the lamp cover

(refer to the illustration).

Replace the used lamp

with a new lamp of the

same power and specifi-

cally designed for house-

hold appliances (the maxi-

mum power is shown on

the lamp cover).

Install the lamp cover.

Tighten the screw to the

lamp cover.

Connect the plug to the

mains socket.

Open the door. Make sure

that the light comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets.

Contact the Service Center.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Comments to this Manuals

No comments

Zanussi ZBA22420SA User Manual Page 19

Comments to this Manuals

Related products and manuals for Refrigerators Zanussi ZBA22420SA