Zanussi ZDC37200W User Manual download pdf (Page 5)

Removing transport safety packaging

Caution! Before use all parts of the transport

packaging must be removed.

1. Open loading door 2. Pull off adhesive strips

from inside machine on

top of drum.

3. Remove foil hose and polystyrene padding from the

machine.

Electrical connection

Details on mains voltage, type of current and the fuses

required should be taken from the rating plate. The rating

plate is fitted near the loading aperture (see “Product de-

scription” chapter).

Connect the machine to an earthed socket, in accordance

with current wiring regulations.

Warning! The manufacturer declines any

responsibility for damage or injury through failure

to comply with the above safety precautions.

Should the appliance power supply cable need to be

replaced, this must be carried out by an authorised service

engineer or a qualified electrician. .

The appliance is supplied with a 13 amp plug fitted. In the

event of having to change the fuse in the plug supplied,

a 13 amp ASTA approved BS 1363/A fuse must be used.

The wires in the mains lead are coloured in accordance

with the following code:

1 Blue - Neutral

2 cord clamp

3 Brown - Live

4 Green and Yellow - Earth

The wire coloured green and yellow must be connected

to the terminal marked with the letter «E» or by the earth

symbol

or coloured green and yellow.

The wire coloured blue must be connected to the terminal

«N» or coloured black.

The wire coloured brown must be connected to the ter-

minal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands

of wire present and the cord clamp must be secure over

the outer sheath.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Warning! The plug must be accessible after

installing the machine.

Permanent connection

In the case of permanent connection it is necessary that

you install a double pole switch between the appliance

and the electricity supply (mains), with a minimum gap

of 3 mm between the switch contacts and of a type suitable

for the required load in compliance with the current elec-

trical regulations.

The switch must not break the yellow and green earth

cable at any point.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments

Zanussi ZDC37200W User Manual Page 5

Comments to this Manuals

Related products and manuals for Tumble dryers Zanussi ZDC37200W