Zanussi ZTAB250 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
resulting in longer drying times and higher energy
consumption. If the hose is fully squashed, the
automatic cut-outs with which the appliance is
fitted can operate. When operating the tumble
dryer, the room temperature must not be lower than
+5°C and higher than +35°C, as it can affect the
performance of the appliance.
If the hose is long and the room
temperature low, the moisture might
condense to water inside the hose.
This is an usual occurrence. To
prevent this water from the hose, it is
recommend to drill a small hole (via. 3
mm) in the lowest point of the hose
and to put a small container below it.
(See picture, point B).
B
There are 3 vent outlets: on the left,
right side and at the rear.
A
1
A
2
Pull the ring nut A from the vent outlet at the rear.1
Screw on the ring nut to the hose and push it into position.2
The not used vents must be sealed with supplied covers.3
DOOR REVERSAL
To make it easier to load or unload the laundry, the
door can be reversed.
WARNING! The door must only be
reversed by an authorised service
engineer.
Please contact your Authorised Service Centre.
The engineer will carry out the door reversal at your
cost.
SPECIAL ACCESSORIES
stack kit
Available from your Authorised
Service Centre or your specialist
dealer
To enable the mounting of the dyer on top of a
front loading washing machine with cover’s
depth between 48 and 60 cm.
Read carefully the instructions supplied with the
kit.
6
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments