Zanussi ZWD81663NW User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
1. Press to pause the appliance.
2. Wait until the door lock indicator goes off.
3. Open the door.
4. Close the door and press again .
The programme or delay start continues to operate.
AT THE END OF THE PROGRAMME
The appliance stops automatically.
The acoustic signal operates (if it is activated).
In the display comes on.
The indicator of the goes off.
The door lock indicator flashes for a few
minutes, then goes off.
You can open the door.
Remove the laundry from the appliance. Make
sure that the drum is empty.
Close the water tap.
Turn the programme knob to position to
deactivate the appliance.
Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
The drum turns regularly to prevent the creases
in the laundry.
The door lock indicator is on. The indicator
flashes. The door stays locked.
You must drain the water to open the door.
To drain the water:
1. Press . The appliance drains the water and
spins.
2. When the programme is completed, the door
lock indicator flashes for a few minutes.
When it goes off, you can open the door.
3. Turn the programme knob to position to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates.
The energy saving status decreases the energy
consumption when the appliance is on the stand
by.
All indicators and the display go off.
The indicator of the flashes slowly
Press one of the options to deactivate the
energy saving status.
If you set a programme or an option
that ends with water in the drum, the
energy saving status function doesn't
activate to remind you to drain the
water.
DAILY USE - DRYING ONLY
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
DRYING SETTING
WARNING! Make sure that the
water tap is open.
1. Turn the programme knob to to activate the
appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the programme
applicable for the items to dry. The display
shows the drying indicator
.
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
DRYING AT AUTOMATIC LEVELS
The laundry can be dried at pre-defined levels of
dryness:
1. Press again and again until the display
shows one of the dryness level indicator:
: IRON DRY level indicator for cotton
items
: CUPBOARD DRY level indicator for
cotton and synthetic items
: EXTRA DRY level indicator for cotton
items
17
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments