Zanussi FCS 1020 C User Manual download pdf (Page 13)

Cleaning the drawer recess

Having removed the draw-

er, use a small brush to

clean the recess, ensuring

that all washing powder

residue is removed from

the upper and lower part of

the recess.

Replace the drawer and run the rinse programme with-

out any clothes in the drum.

Cleaning the water inlet filter

If your water is very hard or contains traces of lime deposit,

the water inlet filter may become clogged. It is therefore

a good idea to clean it from time to time.

Turn off the water tap. Un-

screw the water inlet hose.

Clean the filter using a

hard bristle brush. Tighten

up the inlet hose.

The dangers of freezing

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

• Turn off the water supply.

• Unscrew the inlet hose from the supply tap.

• Select a wash programme, start the machine and let

the programme run for a short time.

• Interrupt the programme by turning the programme

selector to

position.

• Place the end of inlet and drain hoses down low, into

the waste gully (floor drain) set into the floor. Make

sure that the end of the hose does not go below the

water level in the gully's (drain's) water tap.

• Select the programme "Drain" and let it run until it is

finished.

•

Turn the programme selector to

position. When

you intend to start the machine up again, make sure

that the room temperature is above 0 °C.

The appliance is only to be used and stored indoors at

normal room temperature. The manufacturer is not re-

sponsible for any frost damage.

What to do if…

Certain problems are due to lack of simple maintenance

or oversights, which can be solved easily without calling

out an engineer. Before contacting your local Service

Centre, please carry out the checks listed below.

During machine operation it is possible that the End pilot

light blinks to indicate that the machine is not working:

• 1 flash: problem with the water supply.

• 2 flashes: problem with the water draining.

• 4 flashes: door open.

Once the problem has been eliminated, press the button

START to restart the programme. If after all checks, the

problem persists, contact your local Service Centre.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

Zanussi FCS 1020 C User Manual Page 13

Comments to this Manuals

Related products and manuals for Washing machines Zanussi FCS 1020 C