Zanussi WD15INPUT User Manual download pdf (Page 29)

Water inlet

Connect the water inlet hose to a tap with a 3/4" thread

after having inserted the small filter “A” supplied with

the machine.

The other end of the inlet hose which connects to the

machine can be turned in any direction. Simply loosen

the fitting, rotate the hose and retighten the fitting,

making sure there are no water leaks.

The inlet hose must not be lengthened. If it is too short

and you do not wish to move the tap, you will have to

purchase a new, longer hose specially designed for this

type of use.

Water drainage

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the plastic hose

guide supplied with the machine.

In this case, make sure the end cannot come unhooked

when the machine is emptying.

This could be done by tying it to the tap with a piece of

string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm above

the ground.

Directly into a drain pipe at a height of not less than

60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated,

i.e. the inside diameter of the drain pipe must be larger

than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the

floor; only the part near the drainage point must be

raised.

P0003

P0022

P0021

P0023

1 2 ... 24 25 26 27 28 29 30 31

No comments

Zanussi WD15INPUT User Manual Page 29