Zanussi ZWSO6100V User Manual download pdf (Page 14)

Emergency drain

Because of a malfunction, the appliance cannot

drain the water.

If this occurs, do steps (1) through (10) of 'To

clean the drain pump'.

If necessary, clean the pump.

When you drain the water with the emergency

drain procedure, you must activate again the

drain system:

1. Put 2 litres of water in the main wash com-

partment of the detergent dispenser.

2. Start the programme to drain the water.

Frost precautions

If the appliance is installed in an area where the

temperature can be less than 0 °C, remove the

remaining water from the inlet hose and the

drain pump.

1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. Remove the water inlet hose

4. Put the two ends of the inlet hose in a con-

tainer and let the water flow out of the

hose.

5. Empty the drain pump. Refer to the emer-

gency drain procedure

6. When the drain pump is empty, install the

inlet hose again.

Warning! Make sure that the temperature

is more than 0 °C before you use the

appliance again.

The manufacturer is not responsible for

damages caused by low temperatures.

Troubleshooting

The start of the appliance does not occur or the

appliance stops during operation.

First try to find a solution to the problem (refer

to the table). If not, contact the Service.

During appliance operation it is possible that

the red indicator of button Start flashes and

one of the indicators comes on, to show that the

appliance does not operate:

•

: the appliance does not fill with water.

•

: the appliance does not drain the water.

•

: the appliance door is open or not closed

correctly.

Problem Possible solution

The appliance does not

start.

Make sure that the mains plug is connected in the mains socket.

Make sure that the appliance door is closed.

Make sure that there is not a damaged fuse in the household fuse box.

Make sure that the button Start/Pause has been pressed.

If the delay start is set, cancel the setting or wait for the end of the countdown.

Make sure that the programme knob is in the correct position.

Deactivate the Child Lock function if it is on. This function is not available for all the

models.

The appliance does not

fill with water.

Make sure that the water tap is opened.

Make sure that the pressure of the water supply is not too low. For this information,

contact your local water authority.

Make sure that the water tap is not clogged.

www.zanussi.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Zanussi ZWSO6100V User Manual Page 14

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWSO6100V