Zanussi ZHC951X/GB User Manual download pdf (Page 6)

6

Before carrying out any maintenance

or cleaning isolate the cooker hood

from the mains supply.

The cooker hood must be kept clean,

as a build up of grease or fat can be a

fire hazard.

External Cleaning

Wipe the cooker hood frequently with warm soapy

water using a mild detergent.

Never use scouring pads or abrasive

cleaners.

Never use excessive amounts of water

when cleaning particularly around the

control panel.

Metal Grease Filters

The grease filters absorb grease and dust during

cooking to help keep the cooker hood clean inside.

Cleaning

The filters must be washed once every

month, using a normal household

detergent; their compact dimension also

enables them to be washed in a

dishwasher. Allow to dry completely

before replacing.

Removing and replacing the filters

Remove the filters one at a time, press

against the metal actuator to release the

spring catch as illustrated. When

replacing, ensure that the handles face

outwards.

Charcoal Filter

In the recirculation mode the charcoal filter

absorbs smells and unwanted odours.

The charcoal filter cannot be cleaned or

regenerated, and must be replaced approximately

every 4 months, or more frequently if the hood is

subjected to heavy usage.

Replacing the charcoal filter

First remove the metal grease filters.

Remove the saturated activated charcoal

filter by releasing the fixing hooks as

illustrated.

5

Position the new charcoal filter in the

position marked and while holding the

filter replace the fixing hooks as

illustrated.

This appliance can be a possible fire

hazard if the grease and charcoal

filters are not cleaned and replaced as

recommended.

Changing the Spot Lamps

Remove the two screws fixing the

lighting support.

Remove the spot lamp from the holder

by pulling the lamp downwards.

Replace the spot lamp by inserting the

two pins at the base of the lamp into

the holes in holder and pushing into

position.

Replace the lighting support, ensuring it

is located correctly and fix back into

position using the two screws.

If one of the spot lamps has failed to function

check that the lamp is fully seated into the lamp

holder. If lamp failure has occurred then it

should be replaced with a 12V 20W M262

halogen spot lamp.

Replacement filters and lamps can be

obtained from your local Service Force

Centre.

MAINTENANCE AND CLEANING

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments