Zanussi Z 56/3 SA Specifications download pdf (Page 18)

Positioning the inner shelves

The walls of the refrigerator are equipped with

runners so that shelves can be positioned as

desired.

D040

PR263

PR260

Positioning the door shelves

To permit storage of food packages of various sizes,

the door shelves can be adjusted in height.

To do this proceed as shown in the diagram.

INSTALLATION

Positioning

This appliance is designed to operate in ambient

temperatures between 10¡C (50¡F) and 32¡C (90¡C).

It should be located in a dry atmosphere, out of

direct sunlight and away from extreme temperature

e.g. not next to a boiler or radiator, or in a very cold

room e.g. an outhouse, where the temperatures may

fall below 10¡C (50¡F). If these temperatures are

exceeded i.e. colder or warmer, then the appliance

may not operate correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There

must also be at least 100 mm (4Ó) distance between

the top of the cabinet and any overhanging kitchen

furniture (A). Ideally, the appliance should not be

positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of

the appliance. Do not obstruct the space

underneath. The back of the cabinet may be placed

close to the wall but must not touch it. DO NOT

install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the

adjustable foot, or feet, at the bottom of the cabinet

using your fingers.

D200

NP002

100 mm10 mm

10 mm

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on ÒDoor reversal directionsÓ paragraph.

PR60

45°

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be fitted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in the

diagram. Then turn them through 45¡ (arrow (A)

vertical) until they lock into place.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Zanussi Z 56/3 SA Specifications Page 18

Comments to this Manuals

Related products and manuals for Fridge-freezers Zanussi Z 56/3 SA