Zanussi ZRA40100XA User Manual download pdf (Page 22)

4. If needed replace the lamp with a light of

similar characteristic and power. It is

suggested to use Osram PARATHOM

SPECIAL T26 0.8 Watts.

5. Install the lamp cover.

6. Connect the appliance.

7. Open the door. Make sure that the lamp

comes on.

2

1

Installation

WARNING!

Refer to Safety chapters.

Positioning

This appliance can be installed in a dry, well

ventilated indoor where the ambient

temperature corresponds to the climate class

indicated on the rating plate of the appliance:

Climate

class

Ambient temperature

SN +10°C to + 32°C

N +16°C to + 32°C

ST +16°C to + 38°C

T +16°C to + 43°C

Some functional problems might

occur for some types of models

when operating outside of that

range. The correct operation can

only be guaranteed within the

specified temperature range. If you

have any doubts regarding where to

install the appliance, please turn to

the vendor, to our customer service

or to the nearest Service Centre

Location

CAUTION!

It must be possible to disconnect

the appliance from the mains power

supply; the plug must therefore be

easily accessible after installation.

The appliance should be installed well away

from sources of heat such as radiators, boilers,

direct sunlight etc. Ensure that air can circulate

freely around the back of the cabinet. To ensure

best performance, if the appliance is positioned

below an overhanging wall unit, the minimum

distance between the top of the cabinet and the

wall unit must be at least 100 mm . Ideally,

however, the appliance should not be

positioned below overhanging wall units.

Accurate levelling is ensured by one or more

adjustable feet at the base of the cabinet.

A B

20mm

min

100mm

Electrical connection

• Before plugging in, ensure that the voltage

and frequency shown on the rating plate

correspond to your domestic power supply.

• The appliance must be earthed. The power

supply cable plug is provided with a contact

for this purpose. If the domestic power

supply socket is not earthed, connect the

appliance to a separate earth in compliance

with current regulations, consulting a

qualified electrician.

22 www.zanussi.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Comments to this Manuals

No comments