Zanussi ZDG322X User Manual

GAS HOBZDG 322INSTRUCTION BOOKLETPlease read this instruction booklet before using the applianceGB

10OVERALL DIMENSIONSWidth: 290 mmDepth: 510 mmCUT OUT DIMENSIONSWidth: 270 mmDepth: 490 mmSUPPLY CONNECTIONSGas:R 1/2 inch (1/2 inch male) Rear right

11Important safety requirementsThis hob must be installed in accordance with the GasSafety (Installation and Use) Regulations (Current Edition)and the

12InstallationIMPORTANT: This hob must be installed by acompetent person to the relevant Gas Standards.Any gas installation must be carried out by aco

13These hobs can be inserted in a built-in kitchen unit whosedepth is between 550 and 600 mm. The hobs dimensionsare shown in Fig. 1.Fig. 3FO 0199aa)

14Building over a kitchen unit withdoorProper arrangements must be taken in designing theforniture unit, in order to avoid any contact with the bottom

15Electrical connectionsAny electrical work required to install this hobshould be carried out by a qualified electrician orcompetent person, in accord

16Fault FindingPreliminary Electrical SystemsCheckA. EARTH CONTINUITY CHECK - Appliance mustbe electrically disconnected - meter set on Ω(Ohms) x 1 sc

17Ignition System / Gas IgnitionYESCheck plug top fuseandreplace if necessaryCheck polarity andearth continuity ofsupply pointCheck earth continuityof

18CommissioningWhen the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below.- T

19

2

Grafiche MDM - Forlì35690-8301 07/05 From the Electrolux Group. The world’s No.1 choice.The Electrolux Group is the world’s largest produce

3Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. If you needassistance, contact our Customer Ca

4This appliance complies with the followingE.E.C. Directives:* 73/23 - 90/683(Low VoltageDirective);* 93/68 (General Directives);* 89/336 (Electromagn

5OperationHob burnersThe hob burner control knobs are situated on the hob frontpanel. The symbols on the knobs mean that :z there is no gas supplyther

6Maintenance and CleaningBefore any maintenance or cleaning can be carriedout, you must DISCONNECT the hob from theelectricity supply.The hob is best

7Something Not Working?If the hob is not working correctly, please carry out the following checks before contacting your local Service ForceCentre.

8Customer Care DepartmentFor general enquiries concerning your Zanussi applianceor for further information on Zanussi products, pleasecontact our Cust

9Zanussi Guarantee conditionsWe, Zanussi, undertake that if, within 24 months of thedate of the purchase, this Zanussi appliance or any partthereof is