Zanussi ZGH75524XX User Manual

GETTING STARTED?EASY.User ManualZGH75524XBZGH75524XXZGH76524XXEN User ManualHobGB IE

9.CAUTION! Install the appliance onlyon a worktop with flat surface.POSSIBILITIES FOR INSERTIONThe panel installed below the hob must be easy toremove

CONTROL KNOBSymbol Descriptionno gas supply / off positionignition position / maximumgas supplySymbol Descriptionminimum gas supplyDAILY USEWARNING! R

CAUTION! In the absence ofelectricity you can ignite the burnerwithout electrical device; in this caseapproach the burner with a flame, turnthe contro

CARE AND CLEANINGWARNING! Refer to Safety chapters.GENERAL INFORMATION• Clean the hob after each use.• Always use cookware with a clean base.• Scratch

TROUBLESHOOTINGWARNING! Refer to Safety chapters.WHAT TO DO IF...Problem Possible cause RemedyThere is no spark when you tryto activate the spark gene

LABELS SUPPLIED WITH THE ACCESSORIESBAGStick the adhesive labels as indicated below:MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NO.03

OTHER TECHNICAL DATATOTAL POW-ER:Gas original: G20 (2H) 20 mbar 12,0 kWGas replace-ment:G30 (3+) 28-30 mbar 832 g/hG31 (3+) 37 mbar 818 g/hElectric su

Energy efficiency per gas burner(EE gas burner)Left rear - Semi-rapid 55.9%Right rear - Rapid 56.4%Centre middle - Multi Crown 55.0%Left front - Semi-

18

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP867345143-C-362018

• NEVER try to extinguish a fire with water, but switch off theappliance and then cover flame e.g. with a lid or a fire blanket.• CAUTION: The cooking

• Do not install the appliance adjacent to a dooror under a window. This prevents hot cookwarefalling from the appliance when the door or thewindow is

• Used oil, that can contain food remnants, cancause fire at a lower temperature than oil usedfor the first time.• Do not put flammable products or it

813 Current Editions and the ETCI Rules forElectrical Installations.Provision for ventilationDetailed recommendations are contained in thefollowing Br

4. Assemble the parts, follow the same procedurebackwards.5. Replace the rating plate (it is near the gassupply pipe) with the one for the new type of

• N — Neutral terminal• or E — Earth terminalBefore carrying out the connection, make sure:1. The limiter valve and the electrical system cantake the

ASSEMBLY1.2.3.min. 55 mmmin. 650 mm560 mm20+min. 150 mm30 mm480 mm20+min. 600 mm4.50 mm400 mmIf a furniture unit is installed at adistance of 400