Zanussi ZGL642TX User Manual

ENUser manualHobZGL642TIE GB

When the final connection has been made, it isessential that a thorough leak test is carried outon the hob and installation.Make sure that the main co

contractor who is on the roll of the National In-spection Council for Electrical Installation Con-tracting [NICEIC]).The manufacturer refuses to be he

To replace the connection cable use onlyH05V2V2-F T90 or equivalent type. Makesure that the cable section is applicable to thevoltage load and the wor

Technical informationHob dimensionsWidth: 580 mmLength: 500 mmHob recess dimensionsWidth: 550 mmLength: 470 mmHeat inputRapid burner: 3.0 kWSemi-rapid

potential negative consequences for theenvironment and human health, which couldotherwise be caused by inappropriate wastehandling of this product. Fo

15www.zanussi.com

www.zanussi.com/shop 397220502-A-492012

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Product description _ _ _ _ _ _ _ _ _ _ _ _

• Unattended cooking on a hob with fat or oil can be dangerousand may result in fire.• Never try to extinguish a fire with water, but switch off the a

moved from the holder), earth leakage tripsand contactors.Gas connection• All gas connections should be made by aqualified person.• Make sure that the

abrasive products, abrasive cleaning pads,solvents or metal objects.DisposalWarning! Risk of injury or suffocation.• Contact your municipal authority

ABCDA) Burner capB) Burner crownC) Ignition candleD) ThermocoupleWarning! Do not keep the control knobpushed for more than 15 seconds.If the burner do

Care and cleaningWarning! Refer to the Safety chapters.Warning! Deactivate the appliance andlet it cool down before you clean it.Disconnect the applia

Problem Possible cause Remedy • Burner cap and crown areplaced uneven• Make sure that the burner capand crown are in correct posi-tions.The flame is

InstallationWarning! Refer to the Safety chapters.Warning! The following instructions aboutinstallation, connection and maintenancemust be carried out