Zanussi ZGF 982 User Manual

GAS HOBZGF 982INSTRUCTION BOOKLETPlease read this instruction booklet before using the applianceGB

10InstallationIMPORTANT: This hob must be installed by acompetent person to the relevant Gas Standards.Any gas installation must be carried out by aco

11FO2564FO 20443Dimensions are given in mm.Building InBuilding over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawer itwill

12Electrical connectionsAny electrical work required to install this hobshould be carried out by a qualified electrician orcompetent person, in accord

13Fault FindingPreliminary Electrical SystemsCheckA. EARTH CONTINUITY CHECK - Appliance mustbe electrically disconnected - meter set on Ω(Ohms) x 1 sc

14Ignition System / Gas IgnitionYESCheck plug top fuseandreplace if necessaryCheck polarity andearth continuity ofsupply pointCheck earth continuityof

15CommissioningWhen the hob has been fully installed it will be necessaryto check the minimum flame setting. To do this, followthe procedure below.- T

16Guarantee/Customer ServiceStandard guarantee conditionsWe, Zanussi-Electrolux, undertake that if within 12 months of the date of the purchase this Z

17This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the periodspecified in the appliance

18

19

2Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. If you needassistance, contact our Customer Ca

Grafiche MDM - Forlì35672-5605 11/06www.zanussi-electrolux.co.uk

3This appliance complies with the followingE.E.C. Directives:* 73/23 - 90/683(Low VoltageDirective);* 93/68 (General Directives);* 89/336 (Electromagn

4Description of the Hob1. Auxiliary Burner2. Semi-rapid Burners3. Ultra-rapid Triple-crown Burner4. Rapid Burner5. Control knobs213452

5OperationHob burnersTo light a burner:z turn the relevant control knob anticlockwise to themaximum position, then push it down to ignite theburner;z

6Maintenance and CleaningBefore any maintenance or cleaning can be carriedout, you must DISCONNECT the hob from theelectricity supply.The hob is best

7Something Not Working?If the hob is not working correctly, please carry out the following checks before contacting your local Service ForceCentre.

8OVERALL DIMENSIONSWidth: 860 mmDepth: 510 mmCUT OUT DIMENSIONSWidth: 830 mmDepth: 480 mmSUPPLY CONNECTIONSGas:R 1/2 inch (1/2 inch male) Rear right h

9FITTING THE GAS HOBWITHOUT A COOKER HOOD ABOVEFITTING THE GAS HOBWITH A COOKER HOOD ABOVE700 mm400 mm400 mm100 mm55 mm50 mm50 mm600 mm700 mm400 mm400