Zanussi ZWC1301 User Manual download pdf (Page 8)

Select the Delay Start by pressing button

Before you start the programme, if you wish to delay the

start, press the button

repeatedly, to select the desired

delay. The corresponding pilot light will light up.

Washing

End

Door

Delay

Start

You must select this option after you have set the pro-

gramme and before you press button Start Pause.

You can cancel or modify the delay time at any moment,

before you press button Start Pause.

Cancelling the delayed start after having pressed button

Start Pause :

1. Set the washing machine to PAUSE by pressing but-

ton Start Pause.

Press the button

repeatedly until the light rele-

vant to the selected delay goes off.

3. Press button Start Pause again to start the pro-

gramme.

Important! The selected delay can be changed only after

selecting the washing programme again.

The door will be locked throughout the delay time (door

locked light lit).

The Delay Start can not be selected with DRAIN or SPIN

programme.

Start the programme by pressing button

To start the selected programme, press this button; the

corresponding pilot light stops flashing and remains lit.

On programme progress display the pilot lights Washing

and Door illuminate to indicate that the appliance starts

operating and the door is locked.

Altering an option or a running programme

It is possible to change any option before the programme

carries it out.

Before you make any change, you must pause the washing

machine by pressing the button

The programme can be changed as long as the button

has not been pressed. Changing a running programme is

possible only by resetting it. Turn the programme selector

dial to and then to the new programme position. Start

the new programme by pressing the button

again.

Interrupting a programme

Press the button

to interrupt a programme which is

running, the corresponding light starts to flash. Press the

button again to restart the programme.

Cancelling a programme

Turn the selector dial to position to cancel a pro-

gramme which is running. Now you can select a new pro-

gramme.

Opening the door after the programme has started

First set the machine to pause by pressing the button

Start.

After some minutes, the door can be opened, when the

following conditions are observed:

• The water temperature is below 55°C.

• The water level is below the bottom edge of the door.

• The machine doesn’t spin.

If you cannot open the door but it is absolutely necessary

to open it you have to switch the machine off by turning

the selector dial to

. After few minutes the door can be

opened

(Pay attention to the water level and temperature !).

After this procedure, it will be necessary to set the pro-

gramme and the options again and then press the button

Start.

At the end of the programme

The machine stops automatically.

The pilot light End illuminates to indicate that the pro-

gramme has finished. The pilot light Door goes out, the

door can be opened and the laundry can be removed.

If at the end of a programme there is water in the tub

(when "Rinse hold" option has been selected), to empty

out the water follow the following instructions:

•

turn the programme selector dial to

• select the «Drain» or «Spin» programme

• press button Start

When the pilot light Door goes out, the door can be

opened and the laundry can be removed.

At the end of the cycle, turn the programme selector dial

to switch the machine off.

Remove the laundry from the drum and carefully check

that the drum is empty. If you do not intend to carry out

another wash, close the water tap.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Zanussi ZWC1301 User Manual Page 8

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWC1301