Zanussi ZWF81463WH User Manual download pdf (Page 15)

CLEANING THE INLET HOSE AND THE VALVE FILTER

1

2

3

1 2 3

45°

20°

4

FROST PRECAUTIONS

If the appliance is installed in an area where the

temperature can be less than 0 °C, remove the

remaining water from the inlet hose and the drain

pump.

Do this procedure also when you want

to do the emergency drain.

1. Disconnect the mains plug from the mains

socket.

2. Remove the water inlet hose.

3. Remove the drain hose from the rear support

and unhook it from sink or spigot.

4. Put the ends of the drain and inlet hose in a

container. Let the water flow out of the hoses.

5. When no more water flows, install the inlet

hose and the drain hose again.

WARNING! Make sure that the

temperature is more than 0 °C before

you use the appliance again. The

manufacturer is not responsible for

damages caused by low temperatures.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

INTRODUCTION

The appliance does not start or it stops during

operation.

First try to find a solution to the problem (refer to

the table). If the problem persists, contact the

Authorised Service Centre.

With some problems, the acoustic signals

operate and the display shows an alarm

code:

•

- The appliance does not fill with water

properly. Start the appliance again by pressing

button. After 10 seconds the door will be

unlocked.

• - The appliance does not drain the water.

• - The appliance door is open or not

closed correctly. Please check the door!

If the appliance is overloaded,

remove some items from the drum

and/or keep pressed the door and

push the button at the same

time until the indicator stops

flashing (see the picture below).

• - The mains supply is unstable. Wait until

the mains supply is stable.

• - No communication between electronic

elements of the appliance. Switch off and

switch on again. The programme was not

finished properly or the appliance stopped too

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments