Zanussi ZWF8147BW User Manual download pdf (Page 13)

STARTING A PROGRAMME WITHOUT THE

FINISH AT OPTION

Touch the button .

• The indicator of the button stops to

flash and stays on.

• The programme starts, the door locks, the

indicator is on.

• The drain pump can operate for a short time

at the beginning of the washing cycle.

After approximately 15 minutes from

the start of the programme:

• The appliance adjusts automatically

the programme duration agree with

the laundry load.

• The display shows the new value.

STARTING A PROGRAMME WITH THE

FINISH AT OPTION

Check if the appliance has the correct hour set.

See in "Clock setting" how to set the appliances's

clock.

First set the programme (and add options) then set

the option .

1. Touch the button to set the desired end

time. With the first touch the time is rounded to

the nearest hour or to the nearest half an hour.

By each next touch the end time increases by

30 minutes segments until maximum range of

20 hours.

1)

The display shows the finish hour you set (e.g.

) and the indicator is on to show that

this option is active.

2. Touch the button :

• The door is locked.

• The appliance starts the countdown.

• When the countdown is completed, the

programme starts automatically and the

actual programme duration counts down in

minutes until the cycle end.

You can cancel or change the set of

the option before you touch the

button . After touching the button

you can only cancel the option .

To cancel the Finish At option:

a. Touch the button

to set the appliance

to pause. The indicator of button

flashes.

b. Touch the button again and again until

the indicator goes off from the display.

Touch the button again to start the

programme immediately.

INTERRUPTING A PROGRAMME AND

CHANGING THE OPTIONS

You can change only some options before they

operate.

1. Touch .

The indicator of this button flashes.

2. Change the options.

If you change any option the option (if set)

will be disabled.

3. Touch again.

The programme continues.

CANCELLING A PROGRAMME

1. Press the button for some seconds to

cancel the programme and to deactivate the

appliance.

2. Press the same button again to activate the

appliance. Now, you can set a new washing

programme.

Before starting the new programme

the appliance could drain the water. In

this case, make sure that the detergent

is still in the detergent compartment, if

not fill the detergent again.

OPENING THE DOOR

While a programme (or the ) operates, the

appliance door is locked. The indicator is on.

CAUTION! If the temperature and

level of the water in the drum are too

high, you cannot open the door.

To open the door during the first minutes of

the cycle (or when the operates) :

1. Touch the button

to pause the appliance.

2. Wait until the indicator goes off.

3. You can open the door.

1) If you keep the button

pressed the digits change in a quicker way.

13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments