Zanussi ZWO3101 User Manual download pdf (Page 16)

Problem Possible cause Possible solution

The programme knob is not in the

correct position.

Turn the programme knob in the correct po-

sition.

The delay start is set.

It is available only for models with

the Delay start.

To start immediately the programme, cancel

the delay start.

The appliance does not

fill with water.

The water tap is closed. Open the water tap.

The water inlet hose is damaged. Make sure that the water inlet hose has no

damages.

The filter in the water inlet hose is

blocked .

Clean the filter. Refer to 'Care and cleaning'.

The water tap is blocked or there

is limescale on it.

Clean the water tap.

The connection of the water inlet

hose is not correct.

Make sure that the connection is correct.

The water pressure is too low. Contact your local water authority.

The appliance does not

drain the water.

The water drain hose is dam-

aged.

Make sure that the water drain hose has no

damages.

The filter of the drain pump is

blocked.

Clean the filter of the drain pump. Refer to

'Care and cleaning'.

The connection of the water drain

hose is not correct.

Make sure that the connection is correct.

A washing programme without

the drain phase is set.

Set the drain programme.

The function Rinse Hold is on. Set the drain programme.

The spin phase does not

operate.

The spin phase is off. Set the spin programme.

The filter of the drain pump is

blocked.

Clean the filter of the drain pump. Refer to

'Care and cleaning'.

Balance problems with the laun-

dry load.

Adjust manually the items in the tub and

start the spin phase again.

There is water on the

floor.

Leakages from the couplings of

the water hoses.

Make sure that the couplings are tight.

Leakages from the drain pump. Make sure that the drain pump filter is tight.

The water drain hose is dam-

aged.

Make sure that the water inlet hose has no

damages.

You cannot open the ap-

pliance door.

The washing programme is in op-

eration.

Let the washing programme end.

There is water in the drum. Set the drain or the spin programme.

The appliance makes an

unusual noise.

Incorrect level of the appliance. Adjust the level of the appliance. Refer to

'Installation'.

You did not remove the packag-

ing and/or the transit bolts.

Remove the packaging and/or the transit

bolts. Refer to 'Installation'.

www.zanussi.com

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Zanussi ZWO3101 User Manual Page 16

Comments to this Manuals

Related products and manuals for Washing machines Zanussi ZWO3101