Zanussi ZDF21001NA User Manual

GETTING STARTED?EASY.User ManualZDF21001WAZDF21001XAZDF21001NAEN User ManualDishwasher

STARTING A PROGRAMMEOpen the water tap, close the door, select a programme, press .OPTION DELAYWith this option you can postpone the start of a prog

AT THE END OF THE PROGRAMME5 minThe indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off.This helps t

• If you use multi-tablets you can select theMultitab option (if available). This optionincreases the cleaning and drying results withthe use of multi

CLEANING THE FILTERSBAC• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C

Problem and alarm code Possible solutionYou cannot activate the appliance. • Make sure that the mains plug is connected to the mainssocket.• Make sure

Problem Possible solutionThe dishes are wet. • The programme does not have a drying phase or has a dryingphase with low temperature.• The rinse aid di

WWW.ZANUSSI.COM/SHOP100006930-A-472014

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if a

• Do not keep the appliance door open without supervision toprevent to fall on it.• Before maintenance, deactivate the appliance and disconnectthe mai

DISPOSALWARNING! Risk of injury orsuffocation.• Disconnect the appliance from the mainssupply.• Cut off the mains cable and discard it.• Remove the do

EASY START1 2 34561On/off indicator2Programme marker3Indicators4Start button5Delay button6Programme knobINDICATORSEnd indicator.Salt indicator. It is

PROGRAMMESProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Pr

Do not use detergent and do not load thebaskets.THE WATER HARDNESS TABLEGerman degrees(°dH)French degrees(°fH)mmol/l Clarke degreesWater softenerlevel

• Release when Delay and start to flash.• Press . Indicators , Delay and flash. The current setting is indicated by the intermittentflashing

ADDING DETERGENT212030ABIf the programme has a prewash phase, put a small quantity of detergent also in compartment B.ADDING MULTI-TABLETS212030PROGRA