Zanussi ZDF24001XA User Manual

GETTING STARTED?EASY.User ManualZDF24001XAEN User ManualDishwasher

ADDING RINSE AID21 4321The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hotrinse phase.DAILY

The function comes into operation:• 5 minutes after the completion of the programme.• After 5 minutes if the programme has not started.STARTING A PROG

Activate or deactivate the Multitab option before the start of the programme. Activate Multitab option onlywhen you use the combi detergent tablets. T

The water softener should be adjusted according tothe hardness of the water in your area. Your localwater authority can advise you on the hardness oft

CLEANING THE FILTERSBAC• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C

The majority of problems that can occur canbe solved without the need to contact anAuthorised Service Centre.Problem and alarm code Possible cause and

Problem and alarm code Possible cause and solutionThe appliance trips the circuit-beaker.• The amperage is insufficient to supply simultaneously all t

Problem Possible cause and solutionTraces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softene

RATING PLATEMod. ... ... ...Prod. No. ... ... ... Ser. No. ...INFORMATION FOR TEST INSTITUTESFor all the necessary information for testperfor

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if a

WWW.ZANUSSI.COM/SHOP100010170-A-132015

• Do not keep the appliance door open without supervision toprevent to fall on it.• Before maintenance, deactivate the appliance and disconnectthe mai

DISPOSALWARNING! Risk of injury orsuffocation.• Disconnect the appliance from the mainssupply.• Cut off the mains cable and discard it.• Remove the do

CONTROL PANEL213451On/off button2Display3Indicators4Delay button5Programme buttonsINDICATORSIndicator DescriptionMultitab indicator.Salt indicator. It

PROGRAMMESProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Pr

SETTINGSPROGRAMME SELECTION MODE The appliance is in programme selection mode when after the activation all the programme indicatorscome on and the di

THE WATER HARDNESS TABLEGerman degrees(°dH)French degrees(°fH)mmol/l Clarke degreesWater softenerlevel47 -50 84 - 90 8.4 - 9.0 58 - 63 1043 - 46 76 -

DEACTIVATING THE RINSE AID DISPENSERWhile the appliance is in user mode:1. Press .• The indicators and are off.• The indicator continues to fla