Zanussi ZDF3020S User Manual download pdf (Page 66)

Install the appliance worktop to the appliance if you want

to use the dishwasher as a freestanding appliance.

The plinth on freestanding appliance is not adjustable.

Adjusting the level of the appliance

Make sure that the appliance is level to close and seal the

door correctly. If the level of the appliance is correct, the

door does not catch on the sides of the cabinet. If the door

does not close correctly, loosen or tighten the adjustable

feet until the appliance is level.

Water connection

Water inlet hose

Connected the appliance to a hot (max. 60°) or cold water

supply.

If the hot water comes from alternative sources of energy

that are more environmentally friendly (e.g. solar or pho-

tovoltaic panels and aeolian), use a hot water supply to

decrease energy consumption.

Connect the inlet hose to a water tap with an external

thread of 3/4”.

Caution! Do not use connection hoses from an old

appliance.

The water pressure must be in the limits (refer to the

chapter 'Technical data'). Make sure that the local water

authority gives you the average mains pressure in your

area.

Make sure that there are no kinks in the water inlet hose

and that the water inlet hose is not squashed or entangled.

Turn the inlet hose to the left or the right to suit the in-

stallation. Fit the locknut correctly to prevent water leaks.

Caution! Do not connect the appliance to new pipes

or pipes that are not used for a long time. Let the

water run for some minutes, then connect the inlet hose.

Drain hose

Connect the water drain

hose to the sink spigot.

max 85 cm

min 40 cm

max 400 cm

The internal diameter must not be smaller than the diam-

eter of the hose.

1 2 ... 61 62 63 64 65 66 67 68

No comments

Zanussi ZDF3020S User Manual Page 66