Zanussi ZDT 6454 User Manual download pdf (Page 25)

Drain hose

Connect drain hose to

the sink. Secure it with

the supplied hose clamp.

Required height: 30 to

100 cm above bottom of

the dishwasher.

Ensure that the hoses

are not kinked, crushed

or entangled.

When connecting the

drain hose to an under

sink trap spigot, the en-

tire plastic membrane

(A) must be removed.

Failure to remove all the

membrane will result in

food particles building up

over time eventually

blocking the dishwasher

drain hose spigot.

If you use a drain hose extension the total

length should not be longer than 4 metres.

Likewise the internal diameter of the couplings

used for connections to the waste outlet must

be no smaller than the diameter of the hose

provided.

Electrical connection

CAUTION!

Safety standards require the appliance to be

earthed.

Prior to using the appliance for the first time,

ensure that the rated voltage and type of supply

on the rating plate match that of the supply

where the appliance is to be installed.

The fuse rating is also to be found on the rating

plate.

Always plug the mains plug into a correctly in-

stalled shockproof socket. Multi-way plugs,

connectors and extension cables must not be

used.

This could constitute a fire hazard through over-

heating.

If necessary, have the domestic wiring system

socket replaced. In case that the electrical ca-

ble has to be replaced, contact your local Serv-

ice Force centre.

The plug must be accessible after the appliance

has been installed.

Never unplug the appliance by pulling on the

cable. Always pull the plug.

The manufacturer accepts no liability for failure

to observe the above safety precautions.

25

Downloaded from DishWasher-Manual.com Manuals

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments