Zanussi ZDT312 User Manual

GBUser manual 2DishwasherZDT312

123Fill the detergent dispens-er (A) with detergent.4If you use a washing pro-gramme with prewashphase, put more detergentin the prewash detergentcomp

Cancelling a washing programme1. Press and hold function buttons B and C until all theprogramme lights come on.2. Release function buttons B and C to

12Fully clean the filters A, Band C below running wa-ter.3To remove filters B and C,turn the handle approxi-mately 1/4 anticlockwise.4Remove the flat

Fault code and malfunction Possible cause and solution• continuous flash of the light of the run-ning programme• intermittent audible signal• 1 flash

The cleaning results are not satisfactoryThe dishes are not clean • The selected washing programme is not applicable for the type of load andsoil.• Th

Warning! To discard the appliance, follow theprocedure:• Pull the mains plug out of the socket.• Cut off the mains cable and mains plug and discardth

34The internal diameter must not be smaller than the diam-eter of the hose.If you connect the water drain hose to a trap spigot underthe sink, remove

17

18

19

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Washing programmes _ _ _ _ _ _ _ _

To buy accessories, consumables and spare parts at our online shop please visit:www.zanussi.co.ukwww.zanussi.com156951470-00-042009

• Do not change the specifications or modify this prod-uct. Risk of injury and damage to the appliance.• Do not use the appliance:– if the mains cable

Indicator lightsEndThe indicator light comes on when the washing pro-gramme is completed. Auxiliary functions:• Level of the water softener.• Activati

Washing programmesWashing programmesProgramme Degree of soil Type of load Programme descriptionHeavy soil Crockery, cutlery,pots and pansPrewashMain w

Use of the applianceRefer to the following instructions for each step of pro-cedure:1. Make a check if the water softener level is correct forthe wate

12Set switch to position 1 or2.Electronic adjustmentThe water softener is set at the factory at level 5.1. Switch on the appliance.2. Make sure that t

Use of rinse aidCaution! Only use branded rinse aid fordishwashers.Do these steps to fill the rinse aid dispenser:1 234Caution! Do not fill the rins

1Arrange service dishesand large lids around theedge of the lower basket.212Use the cutlery grid. If the dimensions of the cutleryprevent use of the c