Zanussi ZRB23200XA User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16
www.zanussi.com
Do not use electrical appliances inside the food storage com-
partments of the appliance, unless they are of the type recom-
mended by the manufacturer.
Do not use water spray and steam to clean the appliance.
Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarlyqualified persons in order
to avoid a hazard.
Safety Instructions
Installation
WARNING! Only a qualified person
must install this appliance.
Remove all the packaging.
Do not install or use a damaged appli-
ance.
Obey the installation instruction sup-
plied with the appliance.
Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
Make sure the air can circulate around
the appliance.
Wait at least 4 hours before connecting
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor.
Do not install the appliance close to
radiators or cookers, oven or hobs.
The rear of the appliance must stand
against the wall.
Do not install the appliance where there
is direct sunlight.
Do not install this appliance in areas
that are too humid or too cold, such as
the construction appendices, garages
or wine cellars.
When you move the appliance, lift it by
the front edge to avoid scratching the
floor.
Electrical connection
WARNING! Risk of fire and electrical
shock.
The appliance must be earthed.
All electrical connections should be
made by a qualified electrician.
Make sure that the electrical information
on the rating plate agrees with the pow-
er supply. If not, contact an electrician.
Always use a correctly installed shock-
proof socket.
Do not use multi-plug adapters and
extension cables.
Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components.
The mains cable must stay below the
level of the mains plug.
Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.
Do not pull the mains cable to dis-
connect the appliance. Always pull the
mains plug.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comments to this Manuals

No comments