Zanussi ZRB23200XA User Manual download pdf (Page 21)

www.zanussi.com

• Commercially available dish washing

detergents may also be used. After cle-

aning wipe with fresh water and rub dry.

• Accumulation of dust at the condenser

increases energy consumption. For this

reason carefully clean the condenser at

the back of the appliance once a year

with a soft brush or a vacuum cleaner.

• After everything is dry place appliance

back into service.

Defrosting of the refrigerator and

freezer

The two compartments of this model, are “no

frost”. This means that there is no build-up

of frost when it is in operation, neither on the

internal walls nor on your food.

The absence of frost is due to the continuous

circulation of cold air inside the compartment,

driven by an automatically controlled fan.

Troubleshooting

Caution! Before troubleshooting,

disconnect the power supply. Only a

qualiﬁed electrician may carry out the

troubleshooting that is not in this

manual.

Important! There are some sounds

during normal use (compressor,

refrigerant circulation).

Problem Possible cause Solution

Appliance dose not work Appliance is not switch on Switch on the appliance.

Mains plug is not plugged in or

is loose

Insert mains plug.

Fuse has blown or is defective. Check fuse, replace if necessary.

Socket is defective. Mains malfunctions are to be

corrected by an electrician.

Appliance cools too much Temperature is set too cold. Turn the temperature regulator to

a warmer setting temporarily.

The food is too warm. Temperature is not properly

adjusted.

Please look in the initial Control

Panel section.

Door was open for an extended

period.

Open the door only as long as

necessary.

A large quantity of warm food

was placed in the appliance

within the last 24 hours.

Turn the temperature regulator to

a colder setting temporarily.

The appliance is near a heat

source.

Please look in the installation

location section.

Heavy build-up of frost, possibly

also on the door.

Door seal is not air-tight (possib-

ly after reversing the door).

Carefully warm the leaking

sections of the door seal with a

hair dryer (on a cool setting). At

the same time shape the warmed

door seal by hand such that it

sits correctly.

Interior light does not work Light bulb is defective. Please look in the replacing lamp

section.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

Zanussi ZRB23200XA User Manual Page 21

Comments to this Manuals

Related products and manuals for Freezers Zanussi ZRB23200XA