Zanussi CZF 145 W Specifications download pdf (Page 16)

OPERATION

Before using

Remove all securing tapes. Wash inside the

appliance with lukewarm water and bicarbonate of

soda (5 ml to 0.5 litre of water).

Do not use soap or detergent as the smell may

linger. Dry thoroughly.

The freezer compartment

The four-star freezer compartment is suitable for

storage of commercially frozen food and for freezing

fresh foods.

Freezing fresh food

It is not necessary to adjust the thermostat setting

when freezing fresh food.

In any 24 hours you can freeze up to 6 kg. of fresh

food.

Place food to be frozen in the bottom drawer of the

freezer as this is the coldest part.

Important

In the event of a power cut, do not open the door.

The food in the freezer will not be affected if the

power cut is short and if the freezer is full. Should

the food begin to thaw, it must be consumed quickly

and must not be re-frozen (see Hints&Tips).

Frozen food storage

When first starting-up or after a period of non use,

before putting the products in the compartment let

the appliance run for at least two hours on the

coldest setting, then turn the thermostat knob to the

normal opertion position.

Do not exceed the storage period indicated by the

manufacturer.

Finally, do not open the door frequently or leave it

open longer than is absolutely necessary.

Setting the temperature

The temperature inside the refrigerator is regulated

by a thermostat with 6 temperature positions and

one «OFF» (O) position.

Position 1 = minimum coldness

Position 6 = maximum coldness

Turn the thermostat dial to the required position.

The intermediate position is usually the most

suitable (3-4).

The thermostat setting can vary as the temperature

inside the refrigeration compartment depends on the

following factors:

– room temperature

– how often the door is opened

– how much food is stored

– position of the appliance

Important

During prolonged periods of abnormally hot weather,

if the thermostat is set on too high a number, the

cooling system may operate continuously and the

fridge cooling plate may not defrost. Turning the

knob to a lower number will cause the automatic

defrosting to resume.

Low Room Temperature Switch

To ensure that the appliance is working efficiently

when the room temperature drops below 16°C, the

switch mounted next to the thermostat control should

be switched on.

No damage can be caused by leaving the switch in

this position for any period of time (see page 12 Low

room temperature operation).However should the

temperature rise above 16°C remember to turn the

switch off

again.

D710

INSTALLATION

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate, which

is located at the left on the inside of the appliance.

The following table shows which ambient temperature is

correct for each climate classification:

SN +10°C to + 32°C

N +16°C to + 32°C

ST +18°C to + 38°C

T +18°C to + 43°C

It should be located in a dry atmosphere, out of direct

sunlight and away from extreme temperature e.g. not

next to a boiler or radiator, or in a very cold room e.g. an

outhouse, where the temperatures may fall below 10°C

(50°F). If these temperatures are exceeded i.e. colder or

warmer, then the appliance may not operate correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There must

also be at least 100 mm (4”) distance between the top of

the cabinet and any overhanging kitchen furniture (A).

Ideally, the appliance should not be positioned beneath

overhanging furniture (B).

There should also be a gap of 25 mm either side of the

appliance. Do not obstruct the space underneath. The

back of the cabinet may be placed close to the wall but

must not touch it. DO NOT install in places with

restricted ventilation.

Adjust the level of the appliance by screwing out the

adjustable foot, or feet, at the bottom of the cabinet

using your fingers.

D200

NP002

100 mm10 mm

10 mm

Important

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Please ensure that when the appliance is

installed it is easily accessible for the engineer in

the event of a breakdown.

PR60

45°

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be fitted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in the

diagram. Then turn them through 45° (arrow (A)

vertical) until they lock into place.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on “Door reversal”.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Zanussi CZF 145 W Specifications Page 16

Comments to this Manuals

Related products and manuals for Fridge-freezers Zanussi CZF 145 W