Zanussi ZRB934PX2 User Manual download pdf (Page 24)

Problem Possible cause Solution

Water flows into the refrig-

erator.

The water outlet is clogged. Clean the water outlet.

Products prevent that water flows

into the water collector.

Make sure that products do not

touch the rear plate.

Water flows on the ground. The melting water outlet does not

flow in the evaporative tray above

the compressor.

Attach the melting water outlet to the

evaporative tray.

There is too much frost

and ice.

Products are not wrapped properly. Wrap the products better.

The door is not closed correctly. Refer to "Closing the door".

The Temperature regulator may be

set incorrectly.

Set a higher temperature.

The temperature in the ap-

pliance is too low.

The Temperature regulator may be

set incorrectly.

Set a higher temperature.

The temperature in the ap-

pliance is too high.

The Temperature regulator may be

set incorrectly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature before

storage.

Many products are stored at the

same time.

Store less products at the same

time.

The temperature in the re-

frigeration is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air circu-

lation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each oth-

er.

Store products so that there is cold

air circulation.

The appliance does not

operate.

The appliance is switched off. Switch on the appliance.

The mains plug is not connected to

the mains socket correctly.

Connect the mains plug to the mains

socket correctly.

The appliance has no power. There

is no voltage in the mains socket.

Connect a different electrical appli-

ance to the mains socket. Contact a

qualified electrician.

The lamp does not work. The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the lamp".

If your appliance is still not working properly af-

ter making the above checks, contact the After

Sales Centre.

Replacing the lamp

1. Disconnect the appliance.

2. Push the movable part to unhook the lamp

cover (1).

3. Remove the lamp cover (2).

4. If needed replace the lamp with a light of

similar characteristic and power. It is sug-

gested to use Osram PARATHOM SPE-

CIAL T26 0.8 Watts.

5. Install the lamp cover.

6. Connect the appliance.

www.zanussi.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Comments to this Manuals

No comments

Zanussi ZRB934PX2 User Manual Page 24

Comments to this Manuals

Related products and manuals for Fridge-freezers Zanussi ZRB934PX2