Zanussi ZRG15800WA User Manual

ENUser manualRefrigeratorZRG15800WA

Closing the door1. Clean the door gaskets.2. If necessary, adjust the door. Refer to "In-stallation".3. If necessary, replace the defective

If the cabinet is placed in a corner and the sidewith the hinges facing the wall, the distance be-tween the wall and the cabinet must be at least10 mm

1. Remove the plugfrom the power sock-et.2. Tilt back the appli-ance carefully so thatthe compressor can-not touch the floor.3. Unscrew the leftfoot.4

Reversibility of the freezer door180˚Electrical ConnectionCaution! Any electrical work required toinstall this appliance should be carried outby a qua

5. Make sure the electricity supply voltage isthe same as that indicated on the appli-ance rating plate.6. Switch on the appliance.The appliance is su

15www.zanussi.com

www.zanussi.com/shop 212000180-A-472012

ContentsSafety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

ponents of the refrigerant circuit becomedamaged.If the refrigerant circuit should become dam-aged:– avoid open flames and sources of ignition– thorou

ing. To achieve sufficient ventilation followthe instructions relevant to installation.• Wherever possible the back of the productshould be against a

Daily useFreezing fresh foodThe freezer compartment is suitable for freezingfresh food and storing frozen and deep-frozenfood for a long time.To freez

frost or ice on the evaporator. If this happens,set the Temperature Regulator toward warm-er settings to allow automatic defrosting andso a saving in

ing must therefore only be carried out by au-thorized technicians.Periodic cleaningThe equipment has to be cleaned regularly:• clean the inside and ac

3. defrost and clean the appliance and all ac-cessories4. leave the door/doors open to prevent un-pleasant smells.Important! If the cabinet will be ke

Problem Possible cause SolutionWater flows on the ground. The melting water outlet does notflow in the evaporative tray abovethe compressor.Attach the