Zanussi ZRG616CW User Manual download pdf (Page 26)

Problem Possible cause Solution

Products prevent that water flows into

the water collector.

Make sure that products do not touch

the rear plate.

Water flows on the ground. The melting water outlet does not flow

in the evaporative tray above the com-

pressor.

Attach the melting water outlet to the

evaporative tray.

The temperature in the appliance

is too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The temperature in the appliance

is too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too high. Let the product temperature decrease to

room temperature before storage.

Many products are stored at the same

time.

Store less products at the same time.

The temperature in the refrigera-

tor is too high.

There is no cold air circulation in the

appliance.

Make sure that there is cold air circula-

tion in the appliance.

Replacing the bulb

If you want to replace the bulb, do these steps:

1. Break the circuit of the appliance.

2. Unscrew the lamp cover securing screw.

3. Unhook the moving part by pressing it as shown in

the figure.

4. Replace the bulb with one of the same power (the

maximum power is shown on the light bulb cover)

5. Fix the lamp cover in place.

6. Screw the lamp cover securing screw.

7. Reconnect the appliance.

8. Open the door and check if the light comes on.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "Installation".

3. If necessary, replace the defective door gaskets. Con-

tact the Service Center.

Technical data

Dimension

Height 850 mm

Width 550 mm

Depth 612 mm

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

Comments to this Manuals

No comments

Zanussi ZRG616CW User Manual Page 26

Comments to this Manuals

Related products and manuals for Fridges Zanussi ZRG616CW