Zanussi ZRX407W User Manual download pdf (Page 23)

• The appliance must not be located close to

radiators or cookers.

• Make sure that the mains plug is accessible

after the installation of the appliance.

• Connect to potable water supply only (If a

water connection is foreseen).

Service

• Any electrical work required to do the servic-

ing of the appliance should be carried out by

a qualified electrician or competent person.

• This product must be serviced by an author-

ized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses

which could damage the ozone layer, in ei-

ther its refrigerant circuit or insulation materials.

The appliance shall not be discarded together

with the urban refuse and rubbish. The insula-

tion foam contains flammable gases: the appli-

ance shall be disposed according to the appli-

cable regulations to obtain from your local au-

thorities. Avoid damaging the cooling unit, es-

pecially at the rear near the heat exchanger.

The materials used on this appliance marked by

the symbol

are recyclable.

Operation

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a

medium setting.

The Temperature Regulator is situated on the

side of the cabinet.

Switching off

To turn off the appliance, turn the Temperature

regulator to the "O" position.

Temperature regulation

The temperature is automatically regulated.

To operate the appliance, proceed as follows:

• turn the Temperature regulator toward lower

settings to obtain the minimum coldness.

• turn the Temperature regulator toward higher

settings to obtain the maximum coldness.

In the ice-making compartment -2 ºC or

lower temperature can be reached if the

Temperature regulator is set according to fol-

lowing table:

Ambient temperature Temperature regula-

tor setting

+10... +16 ºC "1"

+16... +25 ºC "1-2"

+25... +32 ºC "2-3"

+32... +38 ºC "3-4"

However, the exact setting should be chosen

keeping in mind that the temperature inside the

appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance.

Important! If the ambient temperature is high

or the appliance is fully loaded, and the

appliance is set to the lowest temperatures, it

may run continuously causing frost to form on

the rear wall. In this case the dial must be set to

a higher temperature to allow automatic

defrosting and therefore reduced energy

consumption.

First use

Cleaning the interior

Before using the appliance for the first time,

wash the interior and all internal accessories

with lukewarm water and some neutral soap so

as to remove the typical smell of a brand-new

product, then dry thoroughly.

23

www.zanussi.com

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Comments to this Manuals

No comments