Zanussi ZU9145 User Manual download pdf (Page 11)

PR167/1

PR33/2

6. Push cover (C) into guide (A) until it clips into

place.

7. Open the appliance door and the furniture door at

90°. Insert the small square (B) into guide (A). Put

together the appliance door and the furniture door

and mark the holes as indicated in the figure.

Remove the squares and drill holes with Ø 2 mm at

8 mm from the outer edge of the door. Place the

small square on the guide again and fix it with the

screws supplied.

8mm

PR167

PR168

8. Should adjustment of the furniture door be

necessary, use the clearance of slots.

At the end of operations, it is necessary to check if

the door of the furniture closes properly.

9. Push cover (D) into guide (B) until it clips into

place.

Fitting the plinth

Important

For the efficient operation of the appliance,

it is important that the original ventilation

grid is used.

■ For an opening height dimension A=820 mm and a

plinth height dimension a=100 mm, the plinth may

be fitted without adjustments. The same applies to

an opening height dimension B=870 mm and a

plinth height dimension b=150 mm.

■ For plinth

heights greater

than a=100 mm, b=150 mm, a cut should be made

in the plinth, 580 mm wide, in the centre of the

appliance position, leaving a remaining height of

a=100 mm, b=150 mm.

■ Attach plinth to the kitchen units.

Important

The plinth must be positioned at a minimun

distance of 25 mm from the door.

S.I.007

S.I.008

580

a = 100

b = 150

25 - 80

A = 820

B = 870

1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Zanussi ZU9145 User Manual Page 11

Comments to this Manuals

Related products and manuals for Fridges Zanussi ZU9145