Zanussi ZC650 User Manual download pdf (Page 19)

18

Replacement of the nozzles

Every appliance has spare nozzles for every

gas. The whole of every nozzle is marked in

microns on the nozzle.

For changing the hob nozzles:

Remove the pan support;

Remove the burners;

Using a socket spanner 7 unscrew the

nozzles and replace them with those

required for the type of gas in use (see table

no. 1).

Put in place the burners and the pan

supports.

Adjustment of minimum level of plate

burners.

When changing the gas type watch that the

minimum level be correct. A regular flame at

minimum level is about 4 mm; check that,

turning quickly the knob from the maximum

to the minimum position, the burner doesn’t

go out.

OVEN BURNER

− Remove the oven bottom.

− Light the burner (knob on position max-

flow or position 8 for the model ZC 501)

and leave the oven door closed for about

10 min.

− Turn the knob slowly to position min-flow

or position 1.

− Pull out the knob for adjusting of min-flow

− Introduce the screwdriver in the tap's rod

at taps without thermostat or near the rod

in the left part at taps with thermostat, until

to getting a 5mm flame.

− For butane or propane gas the screw must

be well tightened.

− The flame shouldn’t die out when closing

normally the oven door. Try several times.

Adjustment of minimum flow

Remove the oven bottom.

Light the burner (knob on position max-flow)

and leave the oven door closed for about 10

min.

Turn the know slowly to position min-flow.

Pull out the knob for adjusting of min-flow

For butane or propane gas the screw must

be well tightened.

The flame shouldn’t die out when closing

normally the oven door. Try several times.

air adj usting

fixin

g

screw

1 2 ... 14 15 16 17 18 19 20

Comments to this Manuals

No comments