Zanussi ZCG61296XA User Manual download pdf (Page 22)

WARNING! When installation is

complete, make sure that the seal of

each pipe fitting does not leak. To

check the seal use a soap solution, not

a flame.

FLEXIBLE NONMETAL PIPES CONNECTION

If you have an easy access to the connection, you

can use a flexible pipe. The flexible pipe must be

tightly attached by clamps.

In installation always use the pipe holder and the

gasket. The flexible pipe can be applied when:

• it can not get hotter than room temperature,

higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp edges or

corners,

• it's conditions can be easily checked.

When checking the flexible pipe make sure:

• it does not show cracks, cuts, marks of burnings

on the two ends and on its full length,

• the material is not hardened, but shows its

correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not repair the

pipe, but replace it.

The gas supply ramp is on the rear side of the

control panel.

ADJUSTMENT TO DIFFERENT TYPES OF GAS

WARNING! Let only an authorized

person do the adjustment to different

types of gas.

The appliance is set for liquid gas. You

can change it to natural gas, with the

correct injectors.

The gas rate is adjusted to suit.

WARNING! Before you replace the

injectors, make sure that the gas

knobs are in the Off position.

Disconnect the appliance from the

electrical supply. Let the appliance

cool down. There is a risk of injury.

The appliance is set to default gas. To

change the setting choose a pipe

holder from the list. Always use the

gasket sealing.

A CB

A. Gas connection end

B. Natural Gas pipe holder

C. LPG pipe holder

HOB INJECTORS REPLACEMENT

Replace the injectors when you change the gas

type.

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. Remove the injectors with a socket spanner 7.

4. Replace injectors with the ones necessary for

the type of gas you use.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Zanussi ZCG61296XA User Manual Page 22

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZCG61296XA