Zanussi ZCG61296XA User Manual download pdf (Page 23)

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type of

gas supply.

You can find this plate in the bag

supplied with the appliance.

If the supply gas pressure is not constant or it is

different from the necessary pressure, install an

applicable pressure adjuster on the gas supply

pipe.

ADJUSTING THE MINIMUM GAS LEVEL ON

THE HOB BURNER

1. Disconnect the appliance from the electricity.

2. Remove the knob for the hob. If there is no

access to the bypass screw dismount the

control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

WARNING! Put the mains plug

into the mains socket only if all

parts are back into their initial

position. There is a risk of injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the minimum

position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till the flame

becomes minimum and stable.

8. Put the knob for the hob back on.

OVEN INJECTOR REPLACEMENT

1. Remove the bottom plate of the oven cavity to

get access to the oven burner .

2. Carefully remove from the burner the

thermocouple A. Next remove the spark plug B.

3. Unscrew the screw and slowly pull out the

burner.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Zanussi ZCG61296XA User Manual Page 23

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZCG61296XA