Zanussi ZCK95206WA User Manual download pdf (Page 21)

The gas supply ramp is on the rear side of the

control panel.

WARNING!

Before you connect the gas,

disconnect the appliance from the

electricity supply or switch off the

fuse in the fuse box. Close the

primary valve of the gas supply.

Adjustment to different types of gas

WARNING!

Let only an authorized person do the

adjustment to different types of gas.

If the appliance is set for liquid gas

you can change it to natural gas,

with the correct injectors.

The gas rate is adjusted to suit.

WARNING!

Before you replace the injectors,

make sure that the gas knobs are in

the Off position. Disconnect the

appliance from the electrical supply.

Let the appliance cool down. There

is a risk of injury.

The appliance is set to default gas.

To change the setting choose a pipe

holder from the list. Always use the

gasket sealing.

A CB

A) Gas connection end

B) Natural Gas pipe holder

C) LPG pipe holder

Hob injectors replacement

Replace the injectors when you change the gas

type.

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. Remove the injectors with a socket spanner

7.

4. Replace injectors with the ones necessary

for the type of gas you use.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply.

You can find this plate in the

bag supplied with the appliance.

If the supply gas pressure is not constant or it is

different from the necessary pressure, install an

applicable pressure adjuster on the gas supply

pipe.

Adjusting the minimum gas level on the

hob burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the hob. If there is no

access to the bypass screw dismount the

control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

A A

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

www.zanussi.com 21

1 2 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments