Zanussi ZEV6240FBA User Manual download pdf (Page 8)

Problem Possible cause Remedy

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

There is water or fat stains on the

control panel.

Clean the control panel.

The appliance deactivates. You put something on the sensor

field

.

Remove the object from the sen-

sor field.

The residual heat indicator does

not come on.

The cooking zone is not hot be-

cause it operated only for a short

time.

If the cooking zone operated suffi-

ciently long to be hot, speak to the

service centre.

The sensor fields become hot. The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

cooking zones if necessary.

comes on.

The Automatic Switch Off oper-

ates.

Deactivate the appliance and acti-

vate it again.

and a number come on.

There is an error in the appliance. Disconnect the appliance from the

electrical supply for some time.

Disconnect the fuse from the elec-

trical system of the house. Con-

nect it again. If

comes on

again, speak to the service centre.

If you tried the above solutions and cannot re-

pair the problem, speak to your dealer or the

customer service. Give the data from the rating

plate, three digit letter code for the glass ce-

ramic (it is in the corner of the glass surface)

and an error message that comes on.

Make sure, you operated the appliance correct-

ly. If not the servicing by a customer service

technician or dealer will not be free of charge,

also during the warranty period. The instruc-

tions about the customer service and condi-

tions of guarantee are in the guarantee booklet.

Installation instructions

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, record

the information below from the rating plate. The

rating plate is on the bottom of the appliance

casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you as-

semble the appliance into correct built-in

units and work surfaces that align to the

standards.

Connection cable

• Use the correct mains cable of type H05BB-

F Tmax 90°C (or higher) for a single phase or

two phase connection.

• Replace the damaged mains cable with a

special cable (type H05BB-F Tmax 90°C or

higher). Speak to your local Service Centre.

To attach the seal.

• Clean the worktop in the area of the cut out

section.

• Bond the seal stripe supplied on the lower

edge of the appliance along the outer edge

of the glass ceramic. Do not extend it. Let

stay the cut ends in the middle of one side.

When, you cut it to length (add some mm),

push the two ends together.

8

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments