Zanussi ZGG642CN User Manual download pdf (Page 11)

Building In

Cut Out Size

The dimensions of the cut-out are given in the diagram.

550

470

55 min.

Rectangular cut-out size for hob

Dimensions are given in mm.

FO 2098

ON/OFF SWITCH

FLEX

OUTLET

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

FO 0764

Dimensions are given in mm.

20 min

FO 1013

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer

it will be necessary to fit a heat resistant board below

the base of the hob on the underside of the work

surface.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

Building over a kitchen unit

with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the

bottom of the hob which can be heated when it is

operated. The recommended solution is shown in

diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical

assistance is needed. The space behind the kitchen

unit ("b") can be used for connections.

Fitting the hob to the

worktop

Before fitting the hob into the cut out, an adhesive

seal must be fitted to the underside outside edge

(Fig. 4) of the hob. It is essential that no gaps are left

in this seal in order to prevent spillage near the hob

seeping into the cabinet below.

1) Remove the pan supports, the burners caps

and crowns and turn the hob upside down,

taking care the ignition candles are not

damaged in this operation.

2) Place the sealing gasket all around the

glass top edge as shown in diagram 4.

3) Fit the hob in the cut out and push it down

until the glass top and the working top make

contact, as shown in diagram 5.

FO 2320

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zanussi ZGG642CN User Manual Page 11

Comments to this Manuals

Related products and manuals for Hobs Zanussi ZGG642CN