ENZGG65414User ManualHobGB IE AE
However, if the room has a door which opensdirectly to the outside no air vent is requiredeven if the volume is between 5 m³ and 11 m³.If there are ot
which are necessary for the type of gas youuse (see table in "Technical Information"chapter).4. Assemble the parts, follow the sameprocedure
A BCDEA) Green and YellowB) 3 amp fuseC) BrownD) Cord clampE) BlueThe wires in the cord are coloured as follows:Green and yellow - EarthBlue - Neutral
ABA) supplied sealB) supplied bracketsCAUTION!Install the appliance only on aworktop with flat surface.Possibilities for insertionThe panel installed
Bypass diametersBURNER Ø BYPASS 1/100 mmRapid 42Semi-rapid 32Auxiliary 28Other technical dataTOTAL POWER:Gas original: G20 (2H) 20 mbar = 8 kWGas repl
Gas burners for LPG G30/G31 30/30 mbar - only United Arab EmiratesBURNER NORMALPOWER kWMINIMUMPOWER kWINJECTORMARK 1/100mmNOMINAL GASFLOW g/hRapid 2,8
www.zanussi.com/shop867305955-B-212015
ContentsSafety information 2Safety instructions 3Product description 5Daily use 6Hints and tips 7Care and cleaning 7Troubleshooting 8Installation 9Tec
• Unattended cooking on a hob with fat or oil can be dangerousand may result in fire.• Never try to extinguish a fire with water, but switch off theap
• Before carrying out any operation make surethat the appliance is disconnected from thepower supply.• Make sure that the electrical information onthe
• Do not let cookware to boil dry.• Be careful not to let objects or cookware fallon the appliance. The surface can bedamaged.• Do not activate the co
Control knobSymbol Descriptionno gas supply / off positionSymbol Descriptionignition position / maximumgas supplyminimum gas supplyDaily useWARNING!Re
Turning the burner offTo put the flame out, turn the knob to the offposition .WARNING!Always turn the flame down orswitch it off before you remove th
necessary, remove stubborn stains with apaste cleaner.3. After you clean the pan supports, make surethat they are in correct positions.4. For the burn
If you cannot find a solution...If you cannot find a solution to the problemyourself, contact your dealer or an AuthorisedService Centre. Give the dat
Comments to this Manuals